A Division of Ken-Ding Group
P.
O. Box 1394 Kaohsiung City, Taiwan ROC
Tel : 886-7-7169249 Fax : 886-7-2134620
e-Mail
: shiu@ksts.seed.net.tw
e-Mail
: steel@weitronic.com.tw
http://www.weizhou.com.tw/metal&steel/Bearing/Index-english.htm
___________________________________________________________________________________________________
Sphercial Ball Bearing
SKF Bearing Company is the inventor of self-aligning ball bearings which has the relatively advanced technology. Specific models can be found: Basic design of SKF self-aligning ball bearings, SKF seal self-aligning ball bearings and SKF self-aligning ball bearings of extended inner ring.
Structure of
Spherical ball bearings
It is
divided into cylindrical bore tapered bore, the cage made of steel sheet or
synthetic resins. This kind of bearing outer ring raceway is spherical shape, so
the good performance of its self-aligning, can compensate concentricity and
deflection errors, though inclination of inner and outer ring must not exceed 3
degree angle.
Genenally spherical ball bearings have two rows of symmetrical spherical
rollerwhich is also called self-aligning ball bearings). It made of a large
spherical channel outer ring, a double channel inner ring,two row steel ball and
cage. When it rotates, steel ball, cage and inner ring can make a certain degree
toward the outer ring(can automatically adjust axis), and bearings box for
pocessing, the installation of improper occurred axis displacement. But
genenally the largest axis tilt not size 3 degrees. Type code for self-aliging
ball bearing is ¡§1¡¨
Self-aligning ball bearings is mainly bear radial load. In radial load at the
same time, how can carry axial load. Don't usually used to withstand pure axial
load, because if subject to pure axial load of only one column steel ball
bearing. Double row Self-aligning ball bearings have several structure forms,
such as a tapered bore type (K for 1:12); A tapered bore and adapter sleeve or
withdrawal sleeves and extended?inner ring double row self-aligning ball
bearing;A tightening screw in inner ring double row self-aligning ball bearings.
These structural variations can install fixed bearings in the optical axis (uses
in drive shaft). Tight set also can adjust bearing radial clearance.
Self-aligning ball bearings and full ball, no single keep frame, with
double-sides shield. The aperture of this king bearing is not bigger than 10mm,
commonly used for aircraft components. Did not need to lubricate again.
Features:
Mainly
bear radial load as well as smaller axial load.Axial displacement of axial has
self-aligning properties within the limited clearance, allowing normal work in
relatively small inclination, suitable for part of bearing seat hole without
concentricity.
Back Homepage Back steel & Metal page Purchase
¡@
¡@