Accessories Turbine System |
|
DISCHARGE VACUUM
PUMP
At the end of the run,
this device discharges the water contained in the pipe in order
to allow transport and the pipe unwinding easier. |
|
SLOW CLOSING
At the
end of the run, this device allows an automatic closing of the
water inlet and makes it possible to stop the pumping plant in
overpressure. |
|
TWO-SIDES WATER
INLET
Pipe
for the machine feeding on two sides, allowing an easy
connection to the hose. |
|
DISCHARGE VALVE
At the
end of the run, this device allows a large quantity of water, to
discharge causing a line pressure fall, which automatically
stops the pumping plant. |
|
STEP HYDRAULIC
ROTATION
Hydraulic driven
system |
|
OVERSIZED REAR
JACK
Hydraulic driven
system |
|
Electronic compensation
IRRIGAMATIC |
By-Pass
|
Irrigamatic automatically keeps a
constant recovery speed, irrespective of winding diameter, pipe
pressure, and tractive force. Once the wished speed has been
programmed, Irrigamatic detects the real pipe recovery speed by
means of a rear sensor and acting on the by-pass
it automatically corrects the recovery speed until obtaining the
set value
|
Rear sensor
|
IRRIGAMATIC 100
|
- Pipe
recovery speed control. |
IRRIGAMATIC 300
|
- It is
possible to measure the unwound pipe with unwinding operation
end signal (optional) and Wait up to 100 hours without
irrigating.
Automatic irrigation start with initial pause from 0 to 99
minutes. It is possible to program up to 4 recovery speeds on
the same irrigated area.
Final pause from 0 to 99 minutes. Irrigation stop through a
solenoid valve for the slow closing or discharge valve.
Signalling by means of a flash or transmitter for end of run
(optional). Digital display of meters to be rewound and time of
run. Possible to program using hours instead of meters. |
|
|
|